Deep kitchen sinks – You deserve thumbs up if you have finally decided to replace the outdated cast iron sink with a shiny new stainless steel sink. No doubt, your dishes and glasses will thank you too. You will see fewer unintentional breaks and scratches because stainless steel is not as hard and heavy as cast iron. And you will have a sink that is easier to take care of because it does not require shed to keep it clean. You can install your new sink in a couple of hours, and as a helper will do the stainless steel sink installation project goes smoothly.
Measure the size and remove the sink. Measure the width and length of your existing sink. Use these measurements as a guide when shopping for a new deep kitchen sinks. The new sink should not be smaller than the old one. You can always cut a larger opening, but a smaller opening requires replacing your existing countertop. Turn off the water supply valves under the sink cabinet with a wrench. Place a bucket under water supply, and connect the supply and drainage lines. Catch some water with the bucket.
Remove any existing clips or snaps that hold the deep kitchen sinks in place. Slide a knife under the counter surface edges to remove the joints. Lift the cast iron sink up and out of the counter. Center template provided by your stainless steel sink manufacturer over the sink opening. Place the template at least 1? Inches from the outer edge of the disk. Trace the outlines with carpentry. If your dish was not delivered with a template, do your own by turning the sink upside down on top of the magazine, and then trace around the zinc edges.deep kitchen sinks